GREEN STAR SPORTS CARS, Blackpool

12k Service Schedule

Carry out preliminary road test

Check seatbelt operation & mountings

Check operation of all electrical components

Check handbrake operation & lever security. Adjust & lubricate if required

Remove all road wheels and apply anti-seize compound to hubs & wheel studs

Inspect brake pads for wear, calipers for leaks, discs for condition & flexible hoses condition

Remove front & rear pads & check for deterioration

Change brake fluid

Check fuel, clutch, brake pipes & unions for chafing, corrosion and correct routing

Remove exhaust, lubricate prop & check bolts are secure

Change fuel filter

Change engine oil & filter

Change gearbox oil

Change diff oil

Check condition of steering joints, rack gaitors, ball joints and wishbone bushes

Check for fluid leaks from hydraulic pipes and unions (PAS only)

Check diff mounting bolts

Check all suspention fixings for security

Check tyres for correct spec. and damage. Check road wheels for damage & refit to origonal position

Visually check complete underside of vehicle for faults and abnormalities

Check condition of engine & gearbox mounting rubbers

Check seurity of exhaust manifold bolts (Rover engines only)

Check security of rocker covers (Rover engines only)

Change spark plugs

Check distributor cap, ignition leads and low tension wires for deterioration

Check crank sensor for debris (TVR engines only)

Check engine sensor connections for corrosion (TVR engines only)

Change air filter element

Check tappets & adjust if necessary (Speed six engines only) see notes 1

Check tappets & adjust if necessary (V8 Cerbera) see notes 1

Change clutch fluid

Check / top up PAS fluid (where applicable)

Check engine breather / hoses for security and condition

Check throttles and linkage operation and lubricate where possible

Check / adjust throttle stop

Check / top up windscreen washers & check wiper blade condition

Check master cylinder and under bonnet grommets are sealed - reseal if required

Change coolant (every 2 years)

Check / adjust ignition timing & CO with engine at operating temperature (Rover engines)

Check / adjust engine setting on computer with engine at operating temperature (TVR engines only)

Check cooling system for leaks and hoses for security

Check cooling fans operation

Check adjust tyre pressures inc spare

Check headlight alignment & auxiliary lights if fitted

Check / adjust cambers front & rear

Check / adjust tracking front & rear

Check / adjust all hinges, doors, boot, bonnet, locks & catches

Road test vehicle

Centralise steeing wheel if necessary

Wash vehicle & stamp service book

 

NOTES:

1. Adjust tappets for all TVR engines is up to 7 hours extra labour. normally 2 - 3 hours dose the job.

 We have never had to charge more that 3 hours labour for tappet adjustment.